- Purpose. To eliminate or control potential ignition sources resulting from welding, flame cutting, soldering or similar activities which may produce flames or sparks. Provide a safe work/learning environment in University buildings where temporary hot work may be performed. Potential health, safety and property hazards can result from the fumes, gases, sparks, hot metal and radiant energy produced during hot work. These, and other hazards, can be reduced through the implementation of effective controls as outlined in this Policy.
Hot Work. Operations including cutting, welding, Thermit welding, brazing, soldering, grinding, thermal spraying, thawing pipe, installation of torch-applied roof systems or any other similar situation.
Oxygen and fuel gas cylinders should be stored separately with the protective valve caps in place. Except when in use, oxygen and fuel gas cylinders should be stored at least 20 feet apart or separated by a noncombustible wall at least 5 feet high.
In-House
The supervisor issues the Hot Work Permit to his/her own employee(s). Each permit is job specific. The supervisor is then responsible for submitting the permit to Environmental Health and Safety prior to commencing work. At the end of the job, the supervisor must keep this permit on file for a period of not less than one year.
